Protect and recover
Work areas are protected, power is shut off and refrigerant is recovered from the old system as the rules require.
Replacing a tired system or adding cooling to a home that never had it? Learn what a complete installation includes, what moves an estimate, and how a call from Bothell is connected to an independent local HVAC provider.
Free referral service. We are not a contractor: your call is connected to an independent local HVAC provider, who gives the estimate and does the work.

A proper installation measures the house, sizes the equipment to it, removes the old system if there is one, sets and connects the new indoor and outdoor sections, and tests the result before the crew leaves. The equipment is the easy part. Sizing, airflow, electrical and setup decide how well it cools for the next fifteen years or more.
This page is about the installation job itself. If your system is failing but not finished, the AC repair guide for Bothell covers common fixes, and the full replacement guide goes step by step through the whole process.
The right answer depends on what you have now and how the house is built. These are the paths people most often compare:
| Your situation | Common path | Ask about |
|---|---|---|
| Gas furnace, no AC | Matched indoor coil on the furnace with a new outdoor unit | Can the furnace blower move enough air for cooling? |
| Old AC, furnace still good | Replace the outdoor unit and coil together as a matched set | Is the old line set reusable and clean? |
| Old furnace and old AC | Ducted heat pump replacing both | Backup heat and panel capacity |
| No ducts or a hot addition | Ductless mini-split | Number of indoor heads and line runs |
If you are leaning toward a heat pump, the heat pump installation guide for Bothell compares dual-fuel and all-electric setups.
Cooling capacity should come from a load calculation, not a rule of thumb. It looks at insulation, windows, orientation, air leakage and the duct system. An oversized unit cools the air quickly, shuts off and leaves the house clammy; an undersized one runs all afternoon without catching up.
In two-story Bothell homes the thermostat downstairs cannot see what the bedrooms feel like. Ask whether the provider will check duct balance, return air upstairs and the option of zoning, because a bigger unit is rarely the fix for one hot floor.
Watch outQuotes that give a tonnage without any measurements are a guess. Ask how the size was chosen and request it in writing.
A typical install follows a set sequence, and a good crew explains each step before starting.
Work areas are protected, power is shut off and refrigerant is recovered from the old system as the rules require.
The old equipment comes out. The new outdoor unit goes on a level pad or bracket and the indoor coil is installed.
Refrigerant lines, drain, wiring and thermostat are connected and sealed, and the lines are pressure tested.
Charge, airflow, electrical draw and temperature split are checked, and you learn the thermostat and filter schedule.
We do not publish prices, because each independent provider sets its own. These factors move a written estimate:
| Factor | Why it matters |
|---|---|
| System type and size | Central AC, a heat pump and a multi-zone mini-split are very different jobs. |
| Efficiency rating | Higher SEER2 equipment usually costs more up front and less to run. |
| Ductwork | Leaky, undersized or damaged ducts may need sealing or partial replacement. |
| Electrical work | A new circuit or panel capacity adds to the job. |
| Access and layout | Attic or crawlspace work, long line runs and tight side yards add labor. |
| Permits and extras | Permit fees, a new thermostat, filtration or a condensate pump. |
To compare two quotes fairly, make sure both list the same capacity and system type, the brand and model numbers, what happens to the ducts, line set and electrical, whether the permit is included, and the labor warranty in writing.
Calls from Bothell are welcome. Lynnwood Air Comfort is a free referral service and we are not a contractor: your call is connected to an independent local HVAC provider, and coverage depends on that provider, so ask about availability for your address. You are never obligated to hire the provider you speak with.
Before work begins, confirm an active Washington contractor registration through the Department of Labor & Industries, a written itemized estimate, who pulls the permit, and the labor warranty.
Usually, yes. A common route is a matched indoor coil on the furnace and a new outdoor unit with a dedicated circuit. The provider should confirm the furnace blower can move enough air for cooling and that the thermostat supports the new equipment.
A straightforward swap of a central system is often finished in a day. Jobs needing new ductwork, electrical upgrades or a different type of system take longer, so ask for a timeline with the estimate.
Replacing heating and cooling equipment usually requires a permit, and electrical work may need its own. Homes inside Bothell city limits go through the city. Ask the provider who pulls the permit and whether an inspection is scheduled.
It is worth pricing both. A heat pump cools like an air conditioner and also heats, and in a newer home it can share heating duty with a gas furnace. Your ducts, electrical panel and current heating system decide whether it fits.
It should be calculated from a load calculation, not guessed from square footage. Ask how the provider chose the size and get the model numbers in writing.
Yes. Calls from Bothell are welcome. Your call is connected to an independent local HVAC provider, and coverage depends on that provider, so ask about availability for your address.
Call to be connected with an independent local HVAC provider, then ask for a written, itemized estimate. Coverage in Bothell depends on the provider, so ask when you call.
(425) 592-3234Free referral service. We are not a contractor: you will be connected with an independent local HVAC provider.